ENGINE SWITCH(for Sedan) INSPECTION

PROCEDURE

  1. INSPECT ENGINE SWITCH

    1. Measure the resistance according to the value(s) in the table below.

      A256118C06

      Standard Resistance

      Tester Connection

      Switch Condition

      Specified Condition

      5 (SS1) - 6 (AGND)

      Not pushed

      10 kΩ or higher

      1 (SS2) - 6 (AGND)

      5 (SS1) - 6 (AGND)

      Pushed

      Below 1 Ω

      1 (SS2) - 6 (AGND)

      If the result is not as specified, replace the engine switch.

    2. Apply battery voltage between the terminals of the switch, and check the illumination condition of the engine switch indicator light.

      Note:

      • If the positive (+) lead and the negative (-) lead are incorrectly connected, the engine switch indicator light will not illuminate.

      • If the voltage is too low, the engine switch indicator light will not illuminate.

      Standard

      Measurement Condition

      Specified Condition

      Battery positive (+) → Terminal 9 (SWIL)

      Battery negative (-) → Terminal 6 (AGND)

      Illuminates
      A256118C07

      *a

      Indicator Light

      -

      -

      If the result is not as specified, replace the engine switch.