ENGINE ASSEMBLY COMPONENTS
ILLUSTRATION
*A |
for Half Cover Type |
*B |
for Full Cover Type |
*C |
w/ Cover |
- |
- |
*1 |
FRONT LOWER BUMPER ABSORBER |
*2 |
NO. 1 ENGINE UNDER COVER |
*3 |
CENTER NO. 4 ENGINE UNDER COVER |
*4 |
REAR ENGINE UNDER COVER LH |
*5 |
REAR ENGINE UNDER COVER RH |
- |
- |
ILLUSTRATION
*1 |
AIR CLEANER CAP WITH AIR CLEANER HOSE |
*2 |
AIR CLEANER CASE SUB-ASSEMBLY |
*3 |
NO. 1 ENGINE COVER SUB-ASSEMBLY |
*4 |
AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY |
 |
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*A |
w/ Air Conditioning System |
- |
- |
*1 |
DISCHARGE HOSE SUB-ASSEMBLY |
*2 |
FUEL TUBE SUB-ASSEMBLY |
*3 |
FUEL VAPOR FEED HOSE |
*4 |
NO. 1 RADIATOR HOSE |
*5 |
NO. 1 TURBO WATER HOSE |
*6 |
NO. 2 RADIATOR HOSE |
*7 |
NO. 4 TURBO WATER HOSE |
*8 |
SUCTION HOSE SUB-ASSEMBLY |
*9 |
UNION TO CONNECTOR TUBE HOSE |
*10 |
NO. 1 RELAY BLOCK COVER |
*11 |
O-RING |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
 |
Compressor oil ND-OIL 8 or equivalent |
- |
- |
ILLUSTRATION
*A |
for CVT |
*B |
for Manual Transaxle |
*1 |
HEATER WATER INLET HOSE A |
*2 |
HEATER WATER OUTLET HOSE A |
*3 |
TRANSMISSION CONTROL CABLE ASSEMBLY |
*4 |
WATER HOSE |
*5 |
NO. 3 ENGINE WIRE |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
*A |
Type A |
*B |
Type B |
*1 |
FRONT CENTER FLOOR BRACE SUB-ASSEMBLY |
*2 |
FRONT EXHAUST PIPE ASSEMBLY (TWC: Rear Catalyst) |
*3 |
COMPRESSION SPRING |
*4 |
EXHAUST PIPE SUPPORT |
*5 |
EXHAUST PIPE GASKET |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
● |
Non-reusable part |
ILLUSTRATION
*A |
for CVT |
*B |
for Manual Transaxle |
*C |
Type A |
*D |
Type B |
*E |
w/ Reinforcement |
- |
- |
*1 |
COLUMN HOLE COVER SILENCER SHEET |
*2 |
FRONT CROSSMEMBER SUB-ASSEMBLY |
*3 |
FRONT ENGINE MOUNTING BRACKET LOWER REINFORCEMENT |
*4 |
FRONT ENGINE MOUNTING INSULATOR |
*5 |
FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY |
*6 |
FRONT SUSPENSION MEMBER REAR BRACE LH |
*7 |
FRONT SUSPENSION MEMBER REAR BRACE RH |
*8 |
FRONT SUSPENSION MEMBER REINFORCEMENT LH |
*9 |
FRONT SUSPENSION MEMBER REINFORCEMENT RH |
*10 |
NO. 1 STEERING COLUMN HOLE COVER SUB-ASSEMBLY |
*11 |
NO. 2 STEERING INTERMEDIATE SHAFT ASSEMBLY |
*12 |
REAR ENGINE MOUNTING INSULATOR |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*A |
for CVT |
*B |
for Manual Transaxle |
*C |
w/ Air Conditioning System |
*D |
w/o Air Conditioning System |
*1 |
COMPRESSOR ASSEMBLY WITH PULLEY |
*2 |
ENGINE ASSEMBLY WITH TRANSAXLE |
*3 |
ENGINE MOUNTING INSULATOR LH |
*4 |
ENGINE MOUNTING INSULATOR SUB-ASSEMBLY RH |
*5 |
ENGINE WIRE |
*6 |
FLYWHEEL HOUSING UNDER COVER |
*7 |
GENERATOR ASSEMBLY |
*8 |
V-RIBBED BELT |
*9 |
V-RIBBED BELT TENSIONER ASSEMBLY |
*10 |
COOLER PIPE CLAMP BRACKET |
*11 |
TERMINAL CAP |
*12 |
INTERCOOLER RESERVE TANK ASSEMBLY |
*13 |
WIRE HARNESS CLAMP BRACKET |
*14 |
NO. 1 IDLER PULLEY |
*15 |
IDLER PULLEY BRACKET |
*16 |
IDLER PULLEY COVER PLATE |
*17 |
NO. 1 IDLER PULLEY SUB-ASSEMBLY |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
- |
- |
ILLUSTRATION
*A |
for CVT |
*B |
for Transaxle CVT with Stop and Start System |
*C |
w/o Stop And Start System |
- |
- |
*1 |
CONTINUOUSLY VARIABLE TRANSAXLE ASSEMBLY |
*2 |
DRIVE PLATE AND RING GEAR SUB-ASSEMBLY |
*3 |
DRIVE PLATE AND TORQUE CONVERTER ASSEMBLY SETTING BOLT |
*4 |
FLYWHEEL HOUSING SIDE COVER |
*5 |
STARTER ASSEMBLY |
*6 |
TERMINAL CAP |
*7 |
FRONT DRIVE PLATE SPACER |
*8 |
REAR DRIVE PLATE SPACER |
*9 |
ENGINE ASSEMBLY |
- |
- |
*a |
BLACK: x 1 SILVER: x 5 |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
|
Adhesive 1324 |
★ |
Precoated part |
- |
- |
ILLUSTRATION
*A |
for Manual Transaxle |
*B |
for Transaxle M/T with Stop and Start System |
*C |
w/o Stop And Start System |
- |
- |
*1 |
CLUTCH HOSE |
*2 |
FLYWHEEL HOUSING SIDE COVER |
*3 |
FLYWHEEL SUB-ASSEMBLY |
*4 |
STARTER ASSEMBLY |
*5 |
TERMINAL CAP |
*6 |
ENGINE ASSEMBLY |
*7 |
BLEEDER CLUTCH RELEASE TUBE |
- |
- |
|
N*m (kgf*cm, ft.*lbf): Specified torque |
* |
For use with a union nut wrench |
● |
Non-reusable part |
|
Adhesive 1324 |
★ |
Precoated part |
- |
- |
*T1 |
1st: 49 (500, 36) 2nd: Turn 90° |
- |
- |