HEADLIGHT HOUSING REPLACEMENT

CAUTION / NOTICE / HINT

Note


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Handle components indoors as much as possible to prevent foreign matter from entering and adhering to headlight assembly components.

  • Do not reuse parts which have reduced fastening ability due to thread damage.

  • Use static electricity countermeasures SST (desktop antistatic mat set) and observe all precautions to prevent damage to the system by electrostatic discharge (ESD).

  • Do not touch the inner surface of the lens and metallic surfaces as much as possible, or they may become dirty.

  • Do not allow metallic surfaces to become dirty, as such surfaces become damaged even if they are only lightly wiped with a soft cloth.

  • Do not use solvent to clean components. Only clean them with a dry cloth.

  • When installing components, make sure that the wire harness is not pinched or pulled.

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. REMOVE HEADLIGHT ASSEMBLY LH

    Click here

  2. REMOVE HEADLIGHT HOUSING SUB-ASSEMBLY LH


    1. Disassemble the headlight assembly LH and remove the reusable parts.

      Click here

      Tech Tips


      • If parts are non-reusable or damaged, prepare new parts.

      • w/ AHS:

        The light control LED ECU LH is installed to a new headlight housing sub-assembly LH, so there is no need to remove it from the headlight assembly LH.

    2. Install the reusable and replacement parts to the headlight housing sub-assembly LH.

      Click here

  3. INSTALL HEADLIGHT ASSEMBLY LH

    Click here