ACCUMULATOR ASSEMBLY(for V35A-FTS) REMOVAL

PROCEDURE


  1. AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

    Click here

  2. RELEASE ACCUMULATOR WITH SOLENOID ASSEMBLY INTERNAL PRESSURE

    Note

    If the accumulator with solenoid assembly is removed without first releasing the internal pressure, the automatic transmission fluid may spray out.


    1. Connect the GTS to the DLC3 with the engine switch off.

    2. Turn the engine switch on (IG) and turn the GTS on.

    3. Enter the following menus Powertrain / Stop and Start / Active Test / Accumulator Drive


      Powertrain > Stop and Start > Active Test
      Tester Display
      Accumulator Drive

    4. Turn the accumulator operation on and release the pressure in the accumulator with solenoid assembly.

      Note

      Not available when the engine is running.

      Tech Tips

      By turning the accumulator operation on for 5 seconds, the internal pressure can be released.

    5. Turn the engine switch off and remove the GTS.

  3. REMOVE AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY

    Click here

  4. REMOVE ACCUMULATOR WITH SOLENOID ASSEMBLY


    1. B006BJGC03
      B006DHE Push
      B006B42 Remove

      Using a screwdriver, disconnect the connector of the accumulator with solenoid assembly shown in the illustration.

    2. B006GSY

      Remove the 4 bolts accumulator with solenoid assembly from the automatic transmission case sub-assembly.

    3. B006FGE

      Remove the O-ring from the accumulator with solenoid assembly.

  5. REMOVE TRANSMISSION OIL PIPE


    1. B006DXWC01
      B006DHE Remove

      Remove the transmission oil pipe from the accumulator with solenoid assembly.

    2. B006B32

      Remove the O-ring from the transmission oil pipe.