TRANSMISSION CONTROL CABLE INSTALLATION

PROCEDURE

  1. INSTALL TRANSMISSION CONTROL CABLE ASSEMBLY

    Note:

    Before installing the transmission control cable assembly, check that the park/neutral position switch assembly and shift lever are in neutral.

    1. Put the transmission control cable assembly into the cabin and connect the transmission control cable assembly with the 2 bolts.

      5.0 N*m

      51 kgf*cm

      44 in.*lbf

    2. Connect the transmission control cable assembly to the bracket with a new clip.

    3. Connect the transmission control cable assembly to the control shaft lever with the nut.

      12 N*m

      122 kgf*cm

      9 ft.*lbf

    4. Turn the nut of the transmission control cable assembly 180° counterclockwise. While holding the nut in place, push in the stopper until the stopper clicks twice.

      C203379C02

      *1

      Stopper

      *2

      Nut

      *a

      Push in

      -

      -
      Note:

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable assembly will not be reusable.

      Tip:

      If the stopper cannot be pushed in, slightly turn the nut clockwise and then push in the stopper again.

    5. Connect the outer part of the transmission control cable assembly to the shift lever assembly. Check that the stopper returns to the pulled-out position.

      C203380C02

      *1

      Stopper

      *2

      Nut

      *3

      Shift Lever Assembly

      -

      -
    6. C203381C11

      *1

      Slider

      *2

      Lock Piece

      Slide the slider in the direction shown in the illustration and pull out the lock piece.

    7. C204586

      Connect the end of the transmission control cable assembly to the shift lever assembly.

      Note:

      • Make sure that the lock piece is pulled up.

      • Push on the end of the transmission control cable assembly all the way to the base of the pin.

    8. C278980C01

      *1

      Adjuster Case

      *a

      Push in

      Push the lock piece into the adjuster case and lock it.

      Note:

      Make sure that the lock piece is completely locked by the slider.

  2. INSTALL AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  3. INSTALL AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  4. INSTALL AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  5. INSPECT SHIFT LEVER POSITION

    Click here

  6. INSTALL FRONT CONSOLE BOX

    Click hereClick here