STEERING WHEEL INSTALLATION

PROCEDURE

  1. INSTALL TRANSMISSION SHIFT SWITCH ASSEMBLY (w/ Shift Paddle Switch)

    Click here

  2. INSTALL STEERING PAD SWITCH ASSEMBLY

    1. Attach the 2 claws and 5 pins to install the steering pad switch.

    2. Install the 2 screws.

      2.4 N*m

      24 kgf*cm

      21 in.*lbf

    3. Connect the connector and connector cramp.

  3. INSTALL CRUISE CONTROL SWITCH WIRE (w/ Cruise Control System)

    1. Install the cruise control switch wire.

  4. INSTALL CRUISE CONTROL MAIN SWITCH (w/ Cruise Control System)

    Click here

  5. PLACE FRONT WHEELS FACING STRAIGHT AHEAD

  6. ADJUST SPIRAL CABLE

    Click here

  7. INSTALL STEERING WHEEL ASSEMBLY

    1. C351683E02

      Align the matchmarks on the steering wheel assembly and steering main shaft.

      Table 1. Text in Illustration

      *a

      Matchmark

    2. Install the steering wheel assembly set nut.

      50 N*m

      510 kgf*cm

      37 ft.*lbf

    3. Connect the connectors to the spiral cable sub-assembly.

  8. INSTALL STEERING PAD

    (Click here)

  9. INSPECT STEERING WHEEL CENTER POINT

  10. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click here).

  11. INSPECT SRS WARNING LIGHT

    (Click here)