AUDIO AND VISUAL SYSTEM(for Radio and Display Type) DATA LIST / ACTIVE TEST
DATA LIST
Note:In the table below, the values listed under "Normal Condition" are reference values. Do not depend solely on these reference values when deciding whether a part is faulty or not.
Tip:Using the intelligent tester to read the Data List allows the values or states of switches, sensors, actuators and other items to be read without removing any parts. This non-intrusive inspection can be very useful because intermittent conditions or signals may be discovered before parts or wiring is disturbed. Reading the Data List information early in troubleshooting is one way to save diagnostic time.
Connect the intelligent tester to the DLC3.
Turn the ignition switch to ON.
Turn the intelligent tester on.
Enter the following menus: Body / Navigation System / Data List.
According to the display on the intelligent tester, read the Data List.
Table 1. Audio and Visual System Tester Display
Measurement Item/Range
Normal Condition
Diagnostic Note
Battery Voltage
Battery voltage/ Min.: 0 V, Max.: 24 V
11 to 14 V
-
Active Dimmer
Active dimmer function/ON or OFF
ON: Active dimmer function on
OFF: Active dimmer function off
-
Tail Light SW
Taillight switch/ON or OFF
ON: Light control switch in tail or head position
OFF: Light control switch off
-
Reverse Signal
Reverse signal/ON or OFF
ON: Reverse selected
OFF: Reverse not selected
-
Parking Brake
Parking brake switch/ON or OFF
ON: Parking brake applied
OFF: Parking brake released
-
Ignition
Ignition switch/ON or OFF
ON: Ignition switch ON
OFF: Ignition switch off
"OFF" is also displayed for this item when the ignition switch is turned to ACC
Vehicle Speed
Maximum wheel speed sensor reading/Min.: 0 km/h (0 mph), Max.: 255 km/h (158 mph)
Vehicle stopped: 0 km/h (0 mph)
When driving at constant speed: No large fluctuations