ТОРМОЗ 2-Й ПЕРЕДАЧИ РАЗБОРКА


  1. REMOVE PLANETARY CARRIER THRUST WASHER NO.4


    1. B007SXH

      Remove the thrust washer from the 2nd brake piston.

  2. INSPECT SECOND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY


    1. B007TOS

      Using vernier calipers, measure the free length of the spring together with the spring seat.

      Standard free length
      16.05 mm (0.6319 in.)

  3. REMOVE SECOND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY


    1. B007TSCE02

      Place SST on the spring retainer, and compress the piston return spring with a press.

      SST
      09350-30020   ( 09350-07040 )

      Note


      • Stop compressing when the spring sheet is lowered to the place 1 to 2 mm (0.039 to 0.078 in.) from the snap ring groove, preventing the spring sheet from being deformed.

      • Do not expand the snap ring excessively.

    2. Using a snap ring expander, remove the snap ring.

    3. Remove the spring retainer.

    4. B007VOR

      Remove the piston return spring.

  4. REMOVE SECOND BRAKE PISTON


    1. B007S5U

      Hold the 2nd brake piston by hand, and apply compressed air to the 2nd brake drum to remove the 2nd brake piston.

    2. Remove the 2nd brake piston.

      Tech Tips

      If the piston is at an angle and cannot be removed, press down on the protruding side and apply compressed air again, or wind vinyl tape around the piston end and remove it with needle-nose pliers.

    3. Remove the 2 O-rings from the piston.

  5. INSPECT DIRECT MULTIPLE CLUTCH DISC


    1. B007OK6E02

      Check to see if the sliding surfaces of the disc, the plate and the flange are worn or burnt. If necessary, replace them.

      Tech Tips


      • If the lining of the disc is peeled off or discolored, or even if only a part of the printed numbers is corroded, replace all discs.

      • Before assembling new discs, soak them in ATF for at least 15 minutes.

  6. INSPECT 2ND BRAKE PISTON RETURN SPRING SUB-ASSEMBLY


    1. B007TOS

      Using vernier calipers, measure the free length of the spring together with the spring seat.

      Standard free length
      16.05 mm (0.6319 in.)