CAMERA HEATER INSTALLATION

PROCEDURE

1. INSTALL PRE-COLLISION SAFETY CITY HEATER

   Tip:

   • Perform this step only when necessary.

   • If a pre-collision safety city heater has been removed,replace it with a new one. Install a new pre-collision safety city heater with the pre-collision safety city heater wire as a set.

   • If the sticker is creased or folded it may result inan open circuit.

   • Water may enter and cause a short if the sticker adhesive layer and wiring layer are separated.

   1. Clean the windowshield glass surface.

   2. When work environment temperature is below 15°C:

      1. Using a heat light, heat the pre-collision safety city heater and windshield glass surface.

         Table 1. Heating Temperature

         Item	Temperature
         pre-collision safety city heater	15 to 80 °C (59 to 176 °F)
         Windshield glass	15 to 80 °C (59 to 176 °F)

         CAUTION:

         • Do not touch the heat light and heated parts, touching the heat light may result in burns.

         • Touching heated parts for a long time may result in burns.

         Note:

         Do not heat the pre-collision safety city heater or windshield glass excessively.

   3. 

      *1	Tape
      *a	Long connector
      *b	Short connector

      Connect the 2 connectors to a new pre-collision safety city heater as shown in the illustration.

   4. Remove the release paper from the pre-collision safety city heater.

      Tip:

      After removing the release paper, keep the exposed adhesive free from foreign matter.

   5. Install the pre-collision safety city heater with pre-collision safety city heater wire by aligning it to the specified application position as shown in the illustration.

      

      *a	Specified Application Position	-	-
      	Black ceramic	-	-

      Note:

      • Make sure that the sticker is within the black ceramic area.

      • The double-sided tape of a pre-collision safety city heater will deteriorate if it is detached. Make sure to replace the pre-collision safety city heater with a new one when reatt achment is necessary.

      Tip:

      Apply the pre-collision safety city heater along the bracket.

2. INSTALL PRE-COLLISION SAFETY CITY HEATER WIRE

   1. 

      *a	Clamp
      *b	Guide

      Attach the clamp and 2 guides to install the pre-collision safety city heater wire.

3. INSTALL PRE-COLLISION CITY SENSOR

   Click here