POWER WINDOW REGULATOR MOTOR(for Sedan Rear Side) REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for both the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. PRECAUTION

    Note:

    After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notices before proceeding with work.

    Click hereClick hereClick here

  2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click hereClick hereClick hereClick hereClick here

  3. REMOVE REAR ARMREST ASSEMBLY

    Click here

  4. REMOVE REAR POWER WINDOW REGULATOR SWITCH ASSEMBLY WITH REAR DOOR ARMREST BASE PANEL

    Click here

  5. REMOVE REAR DOOR TRIM BOARD SUB-ASSEMBLY

    Click here

  6. REMOVE REAR DOOR INNER GLASS WEATHERSTRIP

    Click here

  7. REMOVE REAR DOOR SERVICE HOLE COVER

    Click here

  8. DISCONNECT REAR DOOR WEATHERSTRIP

    Click here

  9. REMOVE REAR DOOR GLASS RUN

    Click here

  10. REMOVE NO. 1 REAR DOOR VENT SEAL

    Click here

  11. REMOVE REAR DOOR LOWER WINDOW FRAME SUB-ASSEMBLY

    Click here

  12. REMOVE REAR DOOR QUARTER WINDOW GLASS

    Click here

  13. REMOVE REAR DOOR GLASS SUB-ASSEMBLY

    Click here

  14. REMOVE REAR DOOR WINDOW REGULATOR ASSEMBLY

    Click here