TRANSMISSION CONTROL CABLE REMOVAL

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE

  1. REMOVE NO. 2 CYLINDER HEAD COVER

    Click here

  2. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

    Click here

  3. REMOVE AIR CLEANER FILTER ELEMENT SUB-ASSEMBLY

  4. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

    Click here

  5. REMOVE FRONT FLOOR CENTER BRACE

    Click here

  6. REMOVE NO. 2 ENGINE UNDER COVER

    Click here

  7. DISCONNECT HEATED OXYGEN SENSOR CONNECTOR

    1. C322361

      Disconnect the connector.

    2. Detach the clamp.

  8. REMOVE FRONT EXHAUST PIPE ASSEMBLY

    Click here

  9. REMOVE FRONT FLOOR NO. 2 HEAT INSULATOR

    1. C205852

      Remove the 3 nuts and heat insulator.

  10. REMOVE FRONT FLOOR NO. 1 HEAT INSULATOR

    1. C204635

      Remove the 3 nuts and heat insulator.

  11. REMOVE LOWER NO. 1 INSTRUMENT PANEL FINISH PANEL

    (Click here)

  12. REMOVE TRANSMISSION CONTROL CABLE ASSEMBLY

    1. Move the shift lever to N.

    2. C205853

      Disconnect the end of the transmission control cable assembly from the shift lever assembly.

    3. C205854E06

      Pull out the stopper of the transmission control cable assembly.

      Table 1. Text in Illustration

      *1

      Stopper

      *2

      Nut
      Note:

      Do not remove the stopper. If the stopper is removed, reinstall it to its original position.

    4. Rotate the nut counterclockwise approximately 180° and, while holding the nut in that position, disconnect the transmission control cable assembly from the shift lever assembly.

      Note:

      Do not over-rotate the nut as it will come off the internal spring and the transmission control cable will not be reusable.

    5. C156645

      Remove the nut and disconnect the transmission control cable assembly from the control shaft lever.

    6. Remove the clip and disconnect the transmission control cable from the control cable bracket.

    7. C205855

      Remove the bolt and disconnect the transmission control cable clamp from the rear engine mounting insulator.

    8. C205856

      Remove the 2 nuts and disconnect the transmission control cable assembly.

    9. Pull out the transmission control cable assembly to remove it.

  13. REMOVE NO. 1 TRANSMISSION CONTROL CABLE BRACKET

    1. C322371

      Detach the clamp.

    2. C322372

      Remove the 2 bolts and No. 1 transmission control cable bracket from the continuously variable transaxle assembly.