TELEVISION CAMERA(for Front) REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed and installed, or replaced during front television camera assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Front television camera assembly Front television camera view adjustment Panoramic view monitor system

Click here for Initialization

Click here for Calibration

PROCEDURE


  1. PRECAUTION

    Click here

  2. REMOVE COOL AIR INTAKE DUCT SEAL

    Click here

  3. REMOVE MILLIMETER WAVE RADAR SENSOR ASSEMBLY (w/ Pre-crash Safety System)

    Click here

  4. REMOVE FRONT TELEVISION CAMERA ASSEMBLY


    1. B005O0P

      Disconnect the connector.

    2. B005LYV

      Remove the 2 screws.

    3. Disengage the 2 guides and remove the front television camera assembly.

  5. REMOVE TELEVISION CAMERA WIRE


    1. B005MZ9

      Disconnect the connector and remove the television camera wire.