PANORAMIC VIEW MONITOR SYSTEM, Diagnostic DTC:C1625
| DTC Code | DTC Name |
|---|---|
| C1625 | Open or Short in Steering Angle Sensor +B |
DESCRIPTION
-
This DTC is stored if the television camera controller receives a signal via CAN communication from the steering sensor that indicates a power supply system problem.
-
This DTC is stored if the rear television camera assembly receives a signal via CAN communication from the steering sensor that indicates a power supply system problem.
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C1625 | Open or Short in Steering Angle Sensor +B | Open or short in steering angle sensor +B |
|
Television camera controller |
| DTC No. | Detection Item | DTC Detection Condition | Trouble Area | DTC Output from |
|---|---|---|---|---|
| C1625 | Open or Short in Steering Angle Sensor +B | Open or short in steering angle sensor +B |
|
Rear television camera assembly |
WIRING DIAGRAM
CAUTION / NOTICE / HINT
Note
-
Since the panoramic view monitor system has functions that use the CAN communication system, first check that there is no malfunction in the communication system by inspecting the CAN communication functions in accordance with the "How to Proceed with Troubleshooting" procedures. Then, conduct the following inspection procedure.
-
When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.
-
Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.
-
Inspect the fuses for circuits related to this system before performing the following procedure.
PROCEDURE
-
CHECK HARNESS AND CONNECTOR (STEERING SENSOR POWER SOURCE)
-
Disconnect the K71 steering sensor connector.
-
Measure the resistance according to the value(s) in the table below.
Standard Resistance Tester Connection Condition Specified Condition K71-6 (ESS) - Body ground Always Below 1 Ω -
Measure the voltage according to the value(s) in the table below.
Standard Voltage Tester Connection Condition Specified Condition K71-9 (IG1) - K71-6 (ESS) Engine switch on (IG) 11 to 14 V K71-4 (BAT) - K71-6 (ESS) Always 11 to 14 V Result Proceed to OK NG
OK 
REPLACE STEERING SENSOR Click here
NG
REPAIR OR REPLACE HARNESS OR CONNECTOR
-