PILLAR SPEAKER INSPECTION

PROCEDURE


  1. INSPECT FRONT NO. 3 SPEAKER ASSEMBLY


    1. Check the resistance.


      1. A001XQFC83
        *A for RH
        *B for LH
        *a

        Component without harness connected

        (Front No. 3 Speaker Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        for RH
        Tester Connection Condition Specified Condition
        2 (TWR+) - 4 (TWR-) Always 10 kΩ or higher
        1 (+) - 3 (-) Always 10 kΩ or higher
        1 (+) - 2 (TWR+) Always Below 1 Ω
        3 (-) - 4 (TWR-) Always Below 1 Ω
        for LH
        Tester Connection Condition Specified Condition
        2 (TWL+) - 4 (TWL-) Always 10 kΩ or higher
        1 (+) - 3 (-) Always 10 kΩ or higher
        1 (+) - 2 (TWL+) Always Below 1 Ω
        3 (-) - 4 (TWL-) Always Below 1 Ω

        If the result is not as specified, replace the front No. 3 speaker assembly.