REAR DIFFERENTIAL SIDE GEAR SHAFT OIL SEAL(for 8GR-FKS and V35A-FTS AWD) REPLACEMENT

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure listed below is for the LH side.

PROCEDURE


  1. AIR SUSPENSION CONTROL PROHIBITED (w/ Air Suspension)

    Click here

  2. DRAIN DIFFERENTIAL OIL

    Click here

  3. REMOVE REAR DRIVE SHAFT ASSEMBLY LH

    Click here

  4. REMOVE REAR DRIVE SHAFT OIL SEAL LH


    1. B006G3OC01
      *1 Rear Drive Shaft Oil Seal LH

      Using SST, remove the rear drive shaft oil seal LH.

      SST
      09308-00010

  5. INSTALL REAR DRIVE SHAFT OIL SEAL LH


    1. B006ECOC01
      *1 Rear Drive Shaft Oil Seal LH
      *a Oil Seal Installation Depth

      Using SST and a hammer, install a new rear drive shaft oil seal LH.

      SST
      09518-36030
      09950-70010   ( 09951-07150 )
      Oil seal installation depth
      -0.5 to 0.5 mm (-0.0197 to 0.0196 in.)

      Note


      • Make sure to check the identification marks on the oil seals before installation because the part numbers differ between the left and right sides.

      • To ensure a proper seal, evenly tap in the rear drive shaft oil seal LH.

      • When installing the oil seal, tap it in until its surface is flush with the rear differential carrier.

      • Make sure the difference between the maximum and minimum measured values is less than 0.88 mm (0.0346 in.), as a greater difference may lead to oil leaks.

  6. INSTALL REAR DRIVE SHAFT ASSEMBLY LH

    Click here

  7. ADD DIFFERENTIAL OIL

    Click here