CYLINDER HEAD GASKET INSTALLATION

PROCEDURE

1. INSTALL CYLINDER HEAD GASKET

   1. 

      *a	Lot No.
      	Front of Engine

      Place a new cylinder head gasket on the cylinder block sub-assembly with the Lot No. stamp facing upward.

      Note:

      • Remove any oil from the contact surfaces.

      • Pay attention to the installation direction.

   2. 

      *1	Cylinder Head Gasket
      *a	4 to 7 mm (0.157 to 0.276 in.)
      *b	7 to 10 mm (0.276 to 0.394 in.)
      *c	6.5 to 8 mm (0.256 to 0.315 in.)
      	Front of Engine

      Apply seal packing to the cylinder head gasket as shown in the illustration.

      Seal Packing

      Toyota Genuine Seal Packing Black, Three Bond 1207B or equivalent

      Note:

      • Remove any oil from the contact surfaces.

      • Install the cylinder head gasket within 3 minutes and tighten the cylinder head set bolts within 15 minutes of applying seal packing.

2. INSTALL CYLINDER HEAD SUB-ASSEMBLY

   Click here

3. INSTALL VALVE STEM CAP

   Click here

4. INSTALL VALVE LASH ADJUSTER ASSEMBLY

   Click here

5. INSTALL NO. 1 VALVE ROCKER ARM SUB-ASSEMBLY

   Click here

6. INSTALL CAMSHAFT HOUSING SUB-ASSEMBLY

   Click here