TRANSMISSION WIRE INSTALLATION

PROCEDURE


  1. INSTALL TRANSMISSION WIRE


    1. Coat 2 new O-rings with ATF, and install them to the 2 temperature sensors.

    2. Coat a new O-ring with ATF, and install it to the transmission wire.

    3. Install the transmission wire to the automatic transmission case sub-assembly with the bolt.

      Torque:
      5.4 N*m  { 55 kgf*cm, 48 in.*lbf }

    4. Connect the transmission wire connector.

      Tech Tips

      Push up the lever until the claw of the transmission wire connector makes a connection sound.

  2. INSTALL TRANSMISSION INSULATOR RH


    1. Install the transmission insulator RH to the automatic transmission assembly with the 6 bolts.

      Torque:
      14 N*m  { 143 kgf*cm, 10 ft.*lbf }

  3. CONNECT TRANSMISSION WIRE


    1. B00285DC04
      *1 Temperature Sensor Clamp
      *2 Temperature Sensor

      Connect the 7 solenoid valve connectors.

    2. Install the 2 temperature sensors and the 2 temperature sensor clamps to the transmission valve body assembly with the 2 bolts.

      Torque:
      for Bolt A
      10 N*m  { 102 kgf*cm, 7 ft.*lbf }
      for Bolt B
      11 N*m  { 112 kgf*cm, 8 ft.*lbf }

  4. INSTALL AUTOMATIC TRANSMISSION OIL PAN SUB-ASSEMBLY


    1. B0028PQ

      Install the 4 transmission oil cleaner magnets to the automatic transmission oil pan sub-assembly as shown in the illustration.

    2. Install a new automatic transmission oil pan gasket to the automatic transmission oil pan sub-assembly.

    3. B0025NFC07
      *1 Sleeve
      *2 Automatic Transmission Case Sub-assembly
      *a Correct
      *b Incorrect
      *c Protrusion

      Install the automatic transmission oil pan sub-assembly with automatic transmission oil pan gasket to the automatic transmission case sub-assembly with the 10 bolts.

      Torque:
      7.4 N*m  { 75 kgf*cm, 65 in.*lbf }

      Note


      • Make sure that automatic transmission oil pan gasket seal surface and automatic transmission oil pan sub-assembly contact surface are free of oil and foreign matter.

      • Install the automatic transmission oil pan gasket so that there is no slack in the automatic transmission oil pan gasket, and the entire seal surface is level.

      • Make sure that the 8 protrusions are properly engaged to the automatic transmission oil pan sub-assembly.

      • When installing the automatic transmission oil pan sub-assembly, make sure that the automatic transmission oil pan gasket is not pinched between the sleeve and the seal surface of the automatic transmission case sub-assembly.

  5. ADD AUTOMATIC TRANSMISSION FLUID

    Click here

  6. ADJUST AUTOMATIC TRANSMISSION FLUID

    Click here