POWER SEAT CONTROL ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during position control ECU assembly RH removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here


  • Position control ECU assembly (driver seat)

  • Front seatback frame sub-assembly (driver seat)

  • Front seat adjuster assembly (driver seat)

 Initialize position control ECU Front power seat control system

Click here

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY RH

    Click here

  2. REMOVE POSITION CONTROL ECU ASSEMBLY RH


    1. B0070UZC01
      B00888T Screw
      B0086HX Connector

      Disconnect the 3 connectors.

    2. Remove the 3 screws and position control ECU assembly RH.