CONDENSER(for 8NR-FTS) INSTALLATION

PROCEDURE

  1. INSTALL CONDENSER WITH RECEIVER ASSEMBLY

    1. E317043

      Engage the 2 guides and 2 claws to install the condenser with receiver assembly as shown in the illustration.

      Note:

      Do not damage the condenser with receiver assembly or radiator when installing the condenser with receiver assembly.

      Tip:

      If a new condenser with receiver assembly is installed, add compressor oil to the condenser with receiver assembly as follows.

      Capacity

      Add 40 cc (1.35 fl. oz)

      Compressor Oil

      ND-OIL 8 or equivalent

  2. CONNECT AIR CONDITIONER TUBE ASSEMBLY

    1. Remove the vinyl tape from the air conditioner tube assembly and the connecting part of the condenser with receiver assembly.

    2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the tube joint.

      Compressor Oil

      ND-OIL 8 or equivalent

    3. Install the O-ring to the air conditioner tube assembly.

    4. Connect the air conditioner tube assembly to the condenser with receiver assembly with the bolt.

      5.4 N*m

      55 kgf*cm

      48 in.*lbf

  3. CONNECT DISCHARGE HOSE SUB-ASSEMBLY

    1. Remove the vinyl tape from the discharge hose sub-assembly and the connecting part of the condenser with receiver assembly.

    2. Sufficiently apply compressor oil to a new O-ring and the fitting surface of the hose joint.

      Compressor Oil

      ND-OIL 8 or equivalent

    3. Install the O-ring to the discharge hose sub-assembly.

    4. Connect the discharge hose sub-assembly to the condenser with receiver assembly with the bolt.

      5.4 N*m

      55 kgf*cm

      48 in.*lbf

  4. INSTALL RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY

    1. Install the radiator support to cross member brace sub-assembly with the 2 bolts.

      8.0 N*m

      82 kgf*cm

      71 in.*lbf

    2. Connect the connector.

  5. INSTALL NO. 3 RADIATOR AIR GUIDE

    1. Engage the claw.

    2. Install a new No. 3 radiator air guide with the 2 screws and 2 clips.

  6. INSTALL HOOD LOCK ASSEMBLY

    Click here

  7. INSTALL HEADLIGHT ASSEMBLY LH

    Click here

  8. INSTALL HEADLIGHT ASSEMBLY RH

    Tip:

    Use the same procedure as for the LH side.

  9. CHARGE AIR CONDITIONING SYSTEM WITH REFRIGERANT

    Click here

  10. WARM UP ENGINE

    Click here

  11. INSPECT FOR REFRIGERANT LEAK

    Click here

  12. ADJUST HOOD SUB-ASSEMBLY

    Click here