FRONT STABILIZER BAR(for CVT) INSTALLATION

PROCEDURE

1. INSTALL FRONT STABILIZER BAR BUSHING LH

   1. 

      *1	Stopper
      *2	Dust Lip
      	Front of the Vehicle
      	Inside of the Vehicle

      Install the front stabilizer bar bushing LH to the outside of the stopper on the front stabilizer bar as shown in the illustration.

      Note:

      • Install the front stabilizer bar bushing LH so that the dust lip is facing outward.

      • Install the front stabilizer bar bushing LH so that the cutout is facing the rear of the vehicle.

2. INSTALL FRONT STABILIZER BAR BUSHING RH

   Tip:

   Perform the same procedure as the LH side.

3. INSTALL FRONT STABILIZER BAR

   1. Install the front stabilizer bar to the front suspension crossmember sub-assembly so that the identification mark is positioned on the right side of the vehicle.

      

      *a	Identification Mark	-	-
      	Top of the Vehicle		Front of the Vehicle

4. INSTALL FRONT SUSPENSION MEMBER BRACE

   1. Type A:

      1. 

         *a	Protrusion

         Install the front suspension member front brace LH to the front suspension crossmember sub-assembly with the 4 bolts.

         92 N*m

         938 kgf*cm

         68 ft.*lbf

         Note:

         • Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of B, C, D and A.

         • After installing the front suspension member front brace LH, make sure that the protrusion of the front stabilizer bar bushing LH is visible.

      2. 

         *a	Protrusion

         Install the front suspension member front brace RH to the front suspension crossmember sub-assembly with the 4 bolts.

         92 N*m

         938 kgf*cm

         68 ft.*lbf

         Note:

         • Temporarily tighten the bolt (A), and then fully tighten the 4 bolts in the order of B, C, D and A.

         • After installing the front suspension member front brace RH, make sure that the protrusion of the front stabilizer bar bushing RH is visible.

   2. Type B:

      1. 

         *a	Protrusion

         Install the front suspension member brace to the front suspension crossmember sub-assembly with the 8 bolts.

         92 N*m

         938 kgf*cm

         68 ft.*lbf

         Note:

         • Temporarily tighten the bolt (A), and then fully tighten the 8 bolts in the order of B, C, D and A.

         • After installing the front suspension member brace, make sure that the protrusions of the front stabilizer bar bushings are visible.

5. TEMPORARILY TIGHTEN FRONT LOWER NO. 1 SUSPENSION ARM SUB-ASSEMBLY LH

   Click hereClick hereClick here

6. INSTALL FRONT STABILIZER LINK ASSEMBLY LH

   1. Install the front stabilizer link assembly LH to the front shock absorber assembly with the nut.

      74 N*m

      755 kgf*cm

      55 ft.*lbf

      Note:

      Do not damage the boot of the ball joint.

      Tip:

      If the ball joint turns together with the nut, use a 6 mm hexagon wrench to hold the stud bolt.

7. INSTALL FRONT STABILIZER LINK ASSEMBLY RH

   Tip:

   Perform the same procedure as the LH side.

8. INSTALL FRONT SUSPENSION CROSSMEMBER SUB-ASSEMBLY

   Click hereClick hereClick here