WIPER SWITCH REMOVAL

PROCEDURE


  1. REMOVE STEERING COLUMN COVER

    Note

    Removing the lower steering column cover in the incorrect order will cause the lower steering column cover to break.


    1. Release the tilt and telescopic lever, and fully extend and lower the steering column assembly.

    2. Lock the tilt and telescopic lever.

    3. A005DJ6

      Push the right and left sides of the lower steering column cover to disengage the 4 claws.

    4. A005CJ0

      Insert fingers into the opening of the tilt lever of the lower steering column cover to disengage the claw.

      Tech Tips

      Spread the claw to disengage it.

    5. A005CMAE02

      Turn the steering wheel assembly to the left.

    6. Using a screwdriver, disengage the claw as shown in the illustration.

      Text in Illustration
      *1 Protective Tape

      Tech Tips

      Tape the screwdriver tip before use.

    7. A005ELHE02

      Turn the steering wheel assembly to the right.

    8. Using a screwdriver, disengage the claw as shown in the illustration and remove the lower steering column cover.

      Text in Illustration
      *1 Protective Tape

      Tech Tips

      Tape the screwdriver tip before use.

    9. A005DIB

      Disengage the claw and 2 pins, and remove the upper steering column cover.

  2. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY


    1. A005CJS

      Disconnect the 2 connectors.

    2. Disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

      Note

      If the claw is pushed with excessive force, it may break.