DRIVING SUPPORT SWITCH CONTROL ECU INSTALLATION

PROCEDURE

1. INSTALL DRIVING SUPPORT SWITCH CONTROL ECU

   1. Install the driving support switch control ECU with the bolt.

      12 N*m

      122 kgf*cm

      9 ft.*lbf

   2. Connect the connector.

2. INSTALL INSTRUMENT PANEL BOX ASSEMBLY

   Click hereClick here

3. INSTALL INSTRUMENT PANEL BOX DOOR COVER

   Click hereClick here

4. INSTALL NO. 2 INSTRUMENT PANEL REGISTER ASSEMBLY

   Click hereClick here

5. INSTALL INSTRUMENT CENTER CLUSTER FINISH PANEL GARNISH

   Click hereClick here

6. INSTALL INSTRUMENT SIDE PANEL RH

   Click hereClick here

7. INSTALL NO. 2 INSTRUMENT LOWER PANEL AIRBAG ASSEMBLY

   Click here

8. INSTALL INSTRUMENT LOWER COVER LH

   Click hereClick here

9. INSTALL NO. 2 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY

   Click hereClick here

10. INSTALL INSTRUMENT PANEL FINISH PANEL END RH

    Click hereClick here

11. INSTALL COWL SIDE TRIM BOARD RH

    Click hereClick here

12. INSTALL DOOR SCUFF PLATE ASSEMBLY RH

    Click hereClick here

13. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Note:

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected (Click hereClick hereClick hereClick here).

14. CHECK SRS WARNING LIGHT

    Click here