TILT AND TELESCOPIC MANUAL SWITCH INSTALLATION

CAUTION / NOTICE / HINT

Note


  • Do not replace the spiral cable with sensor sub-assembly with the battery connected and the engine switch on (IG).

  • Do not rotate the spiral cable with sensor sub-assembly without the steering wheel assembly installed, with the battery connected and the engine switch on (IG).

  • Ensure that the steering wheel assembly is installed and aligned straight when inspecting the steering sensor.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

PROCEDURE


  1. INSTALL TILT AND TELESCOPIC SWITCH


    1. Engage the claw to install the tilt and telescopic switch.

    2. Connect the tilt and telescopic connector to the tilt and telescopic switch.

    3. Connect the airbag connector to the spiral cable with sensor sub-assembly.

  2. INSTALL LOWER STEERING COLUMN COVER


    1. B006EEVC01
      *a Felt
      B006DHE Install in this Direction

      Insert the lower steering column cover in the direction indicated by the arrow.

      Note

      Do not damage the tilt and telescopic switch and felt.

    2. Engage the 4 claws to install the lower steering column cover to the upper steering column cover.

    3. Install the 3 screws.

  3. CONNECT CABLE TO NEGATIVE BATTERY TERMINAL

    Click here

    Note

    When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

    Click here

  4. INSTALL LUGGAGE COMPARTMENT MAT SUB-ASSEMBLY

  5. CUSTOMIZE POWER TILT AND POWER TELESCOPIC STEERING COLUMN SYSTEM


    1. Reset the auto tilt away function setting to the previous condition by changing the customize parameter.

      Click here

  6. PERFORM VARIABLE GEAR RATIO STEERING SYSTEM CALIBRATION (w/ VGRS)

    Click here