ROOF DRIP SIDE FINISH MOULDING

INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP (for Standard Roof)

Note

If reusing the clips, do not remove the double-sided tape remaining on the clips and where the clips will be installed on the body.
If installing new clips, remove the double-sided tape remaining where the clips will be installed on the body and clean the body with a non-residue solvent.

Text in Illustration
*1	Adhesive
*a	2 to 3 mm (0.0787 to 0.118 in.) Bead of Adhesive

Apply a 2 to 3 mm (0.0787 to 0.118 in.) bead of adhesive (3M DP-105 or equivalent) to new roof drip side finish moulding clips.

Tech Tips

Adhesive strength (tensile strength): 13.7 MPa (140 kgf/cm², 1987 psi) or more (when the temperature is 23°C (73°F).)

Press and install the 2 roof drip side finish moulding clips.

Install the clips to the positions on the roof panel shown in the illustration. Determine the locations and firmly press and install the 2 roof drip side finish moulding clips after lightly applying adhesive (3M DP-105 or equivalent).

Text in Illustration
*1	Protruding Part	-	-

Standard Dimension
Installation Area	Dimension	Measurement
for Front Side	A	3.5 mm (0.138 in.)
	B	2.5 mm (0.0984 in.)
	C	0.8 mm (0.0314 in.)
for Rear Side	D	3.5 mm (0.138 in.)
	E	0.8 mm (0.0314 in.)
	F	3.5 mm (0.138 in.)

Install the roof drip center side finish moulding when 20 minutes or more have elapsed after pressing and installing the 2 roof drip side finish moulding clips.
Tech Tips
- Initial hardening time: 20 minutes
- Complete hardening time: 48 hours

INSTALL ROOF DRIP CENTER SIDE FINISH MOULDING (for Standard Roof)

Engage the 2 clips and install the roof drip center side finish moulding.

INSTALL ROOF DRIP SIDE FINISH MOULDING CLIP (for Glass Roof)