POWER SEAT CONTROL ECU REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during position control ECU assembly removal/installation are shown below.

Necessary Procedures After Parts Removed / Installed / Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Disconnect cable from negative battery terminal Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Panoramic View Monitor System

Click here


  • Position control ECU assembly (driver seat)

  • Front seatback frame sub-assembly (driver seat)

  • Front seat adjuster assembly (driver seat)

 Initialize position control ECU Front power seat control system

Click here

CAUTION:


  • Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The following procedure is for LHD vehicles.

PROCEDURE


  1. REMOVE FRONT SEAT ASSEMBLY

    Click here

  2. REMOVE POSITION CONTROL ECU ASSEMBLY


    1. B00865LC01
      B00888T Screw
      B0086HX Connector

      Disconnect the 3 connectors.

    2. Remove the 3 screws and position control ECU assembly.