IMMOBILISER SYSTEM(w/ Entry and Start System) PRECAUTION

PRECAUTION FOR DISCONNECTING CABLE FROM NEGATIVE BATTERY TERMINAL

PRECAUTIONS WHEN USING GTS

1. When using the GTS with the engine switch off, connect the GTS to the vehicle and turn a courtesy light switch on and off at intervals of 1.5 seconds or less until communication between the GTS and the vehicle begins. Then select the Model Code "KEY REGIST" under manual mode and enter the following menus: Body Electrical / Entry&Start. While using the GTS, periodically turn a courtesy light switch on and off at intervals of 1.5 seconds or less to maintain communication between the GTS and the vehicle.

2. After all DTCs are cleared, check if the trouble occurs again 10 seconds after turning the engine switch on (IG).

PRECAUTION FOR REGISTRATION

1. If replacing any of the following parts, refer to the Service Bulletin.

   Note:

   Any keys or ECUs for which registration has been performed cannot be reused.

   1. Certification ECU (smart key ECU assembly)

   2. ID code box (immobiliser code ECU)*

      • *: w/ Multi-information Display (Dot Display Type)

   3. Steering lock ECU (steering lock actuator assembly)

   4. Electrical key transmitter sub-assembly

2. After replacing the steering lock ECU (steering lock actuator assembly), confirm the lock/unlock operation of the steering lock.

   Table 1. Operation

   Steering Lock	Operation Condition
   Locks	With the engine switch off, open and close any door.
   Unlocks	Turn the engine switch from off to on (ACC) or on (IG).

PRECAUTIONS FOR TELEPHONE TRANSCEIVER ASSEMBLY (w/ Blocking System)

1. When the telephone transceiver assembly is replaced, it is necessary to set the contract mode.

PRECAUTIONS FOR BATTERY

1. Immediately after disconnecting and reconnecting the battery cable, the entry unlock function may not operate. If this occurs, the entry unlock function can be restored by performing a wireless door lock and unlock operation.

2. When the battery is discharged, if the battery of another vehicle is used to jump start the engine, move the shift lever to P (except Manual Transaxle) and open and close the driver door with the engine switch off before starting the engine.

3. After the battery is removed and reinstalled, be sure to wait 10 seconds or more before the next engine start. The engine may not start immediately after the battery is reinstalled.

   Tip:

   • After disconnecting and reconnecting the battery cable, the engine may not start on the first attempt. If this occurs, turn the engine switch off. The engine will start normally from the second time onward.

   • When the battery cable is disconnected and reconnected, the power source mode returns to the mode it was in before the battery cable was disconnected.