MULTI-MODE MANUAL TRANSAXLE SYSTEM Pattern Select Switch Circuit
| DTC Code | DTC Name |
|---|---|
| Pattern Select Switch Circuit |
DESCRIPTION
While the vehicle is driven with the shift lever in E, the most appropriate gear is automatically selected according to the accelerator pedal opening angle and vehicle speed. During this time, shift control can be switched between easy (E) mode and easy sports (Es) mode by pressing the Es mode switch (combination switch assembly).
WIRING DIAGRAM
PROCEDURE
INSPECT COMBINATION SWITCH ASSEMBLY
-
*a
Component without harness connected
(Es Mode Switch (Combination Switch Assembly))
Remove the Es mode switch (combination switch assembly).
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
8 - 3
Switch being pushed
Below 50 Ω
8 - 3
Switch not being pushed
10 kΩ or higher
Result
Proceed to
OK
NG
-
CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH ASSEMBLY - BODY GROUND)
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
E136-3 - Body ground
Always
Below 1 Ω
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
CHECK HARNESS AND CONNECTOR (COMBINATION SWITCH ASSEMBLY - TCM)
Disconnect the E104 TCM connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
E104-23 (ESSW) - E136-8
Always
Below 1 Ω
E104-23 (ESSW) or E136-8 - Body ground
Always
10 kΩ or higher
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
REPLACE TCM
Replace the TCM.
Result
Proceed to
NEXT