POWER BACK DOOR SYSTEM Power Back Door Warning System does not Operate
| DTC Code | DTC Name |
|---|---|
| Power Back Door Warning System does not Operate |
DESCRIPTION
When the power back door warning system does not operate, one of the following may be malfunctioning: 1) wireless door lock control system, 2) wireless door lock buzzer circuit or 3) multiplex network door ECU.
WIRING DIAGRAM
CAUTION / NOTICE / HINT
The power back door warning function can be customized. Make sure the function is ON.
When replacing the main body ECU (multiplex network body ECU), make sure to replace it with a new one.
PROCEDURE
CHECK OPERATION
Check power back door system operation.
Result
Proceed to
Hazard warning light does not come on
Power back door warning buzzer does not operate
Power back door warning buzzer does not operate PERFORM ACTIVE TEST USING GTSClick here
CHECK WIRELESS DOOR LOCK CONTROL SYSTEM (HAZARD ANSWER-BACK FUNCTION)
Check wireless door lock operation.
w/ Entry and Start System:Click here
w/o Entry and Start System:Click here
Result
Proceed to
Hazard answer-back function operates normally
Hazard answer-back function does not operate
Hazard answer-back function does not operate GO TO WIRELESS DOOR LOCK CONTROL SYSTEM
w/ Entry and Start System:Click here
w/o Entry and Start System:Click here
REPLACE MULTIPLEX NETWORK DOOR ECU
Temporarily replace the multiplex network door ECU with a new or normally functioning one.
Result
Proceed to
NEXT
CHECK POWER BACK DOOR SYSTEM
Check that the power back door hazard warning lights operate normally.
Result
Proceed to
The power back door hazard warning lights operate normally
The power back door hazard warning lights operate abnormally
The power back door hazard warning lights operate normally END (MULTIPLEX NETWORK DOOR ECU WAS DEFECTIVE)
The power back door hazard warning lights operate abnormally REPLACE MAIN BODY ECU (MULTIPLEX NETWORK BODY ECU)
for LHD:Click here
for RHD:Click here
PERFORM ACTIVE TEST USING GTS
Check the Data List for proper functioning of the wireless door lock buzzer.
Body Electrical > Back Door > Active Test
Tester Display
Measurement Item
Control Range
Diagnostic Note
PBD Buzzer
Wireless door lock buzzer sound
ON or OFF
-
Body Electrical > Back Door > Active Test
Tester Display
PBD Buzzer
Result
Proceed to
Wireless door lock buzzer sounds
Wireless door lock buzzer does not sound
CHECK HARNESS AND CONNECTOR (WIRELESS DOOR LOCK BUZZER - MULTIPLEX NETWORK DOOR ECU AND BODY GROUND)
Disconnect the U14 wireless door lock buzzer connector.
Disconnect the U18 multiplex network door ECU connector.
Measure the resistance according to the value(s) in the table below.
Standard Resistance
Tester Connection
Condition
Specified Condition
U14-1 (BZR+) - U18-5 (BZR+)
Always
Below 1 Ω
U14-2 (BZR-) - Body ground
Always
Below 1 Ω
U14-1 (BZR+) or U18-5 (BZR+) - Body ground
Always
10 kΩ or higher
Result
Proceed to
OK
NG
NG REPAIR OR REPLACE HARNESS OR CONNECTOR
REPLACE WIRELESS DOOR LOCK BUZZER
Temporarily replace the wireless door lock buzzer with a new or normally functioning one.
Result
Proceed to
NEXT
CHECK POWER BACK DOOR SYSTEM
Check that the wireless door lock buzzer operates normally.
Result
Proceed to
Wireless door lock buzzer sounds
Wireless door lock buzzer does not sound
Wireless door lock buzzer sounds END (WIRELESS DOOR LOCK BUZZER WAS DEFECTIVE)