FRONT DOOR COURTESY SWITCH(for Hatchback, Wagon) INSTALLATION

CAUTION / NOTICE / HINT

Tip:

  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE

  1. INSTALL FRONT DOOR COURTESY LIGHT SWITCH ASSEMBLY

    1. Using a T30 "TORX" socket wrench, install the front door courtesy light switch assembly with the screw.

      6.3 N*m

      64 kgf*cm

      56 in.*lbf

      Tip:

      There are 2 diameters for the "TORX" screws: 6 mm (0.236 in.) and 7 mm (0.276 in.). The diameter of a supplied "TORX" screw is 7 mm (0.276 in.).

    2. Connect the connector.

  2. INSTALL CENTER PILLAR LOWER GARNISH

    Click hereClick here

  3. INSTALL FRONT DOOR OPENING TRIM WEATHERSTRIP

    for LH Side:Click hereClick here

    for RH Side:Click hereClick here

  4. INSTALL REAR DOOR OPENING TRIM WEATHERSTRIP

    for LH Side:Click hereClick here

    for RH Side:Click hereClick here

  5. INSTALL FRONT DOOR SCUFF PLATE

    Click hereClick here

  6. INSTALL REAR DOOR SCUFF PLATE

    Click hereClick here