HEATED OXYGEN SENSOR INSTALLATION

PROCEDURE

  1. INSTALL HEATED OXYGEN SENSOR (for Bank 1 Sensor 2)

    1. A293363C01

      *1

      Fulcrum Length

      Using SST, install the heated oxygen sensor to the center exhaust pipe assembly.

      09224-00010

      without SST

      44 N*m

      449 kgf*cm

      32 ft.*lbf

      with SST

      40 N*m

      408 kgf*cm

      30 ft.*lbf

      Tip:

      • Use a torque wrench with a fulcrum length of 30 cm (11.8 in.). When using a torque wrench with a fulcrum length that is not 30 cm (11.8 in.), calculate the torque specification for the torque wrench and SST based on the "without SST" torque specification.

        Click hereClick hereClick hereClick hereClick here

      • Make sure SST and the wrench are connected in a straight line.

      Note:

      Do not damage the heated oxygen sensor.

    2. Pass the heated oxygen sensor connector through the floor panel and install the grommet.

    3. Connect the heated oxygen sensor connector.

  2. INSTALL FRONT FLOOR COVER

    Click hereClick here

  3. INSTALL REAR CONSOLE BOX SUB-ASSEMBLY

    Click hereClick here

  4. INSPECT FOR EXHAUST GAS LEAK

    Click hereClick here