REAR CRANKSHAFT OIL SEAL REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the rear engine oil seal removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not Performed Link
Gas leaks from exhaust system Inspection after repair Poor idle, engine start, etc.

Click here


    for AC60E:

  • Replacement of automatic transmission assembly

 Reset memory

  • Large shift shock

  • Engine overruns

Click here


    for AC60E:

  • Replacement of automatic transmission fluid

 ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly

Click here


    for AC60F:

  • Replacement of automatic transmission assembly

 Reset memory

  • Large shift shock

  • Engine overruns

Click here


    for AC60F:

  • Replacement of automatic transmission fluid

 ATF thermal degradation estimate reset The value of the Data List item "ATF Thermal Degradation Estimate" is not estimated correctly

Click here

PROCEDURE


  1. REMOVE MANUAL TRANSMISSION UNIT ASSEMBLY (for Manual Transmission)


  2. REMOVE AUTOMATIC TRANSMISSION ASSEMBLY (for Automatic Transmission)


  3. REMOVE CLUTCH COVER ASSEMBLY (for Manual Transmission)

    Click here

  4. REMOVE CLUTCH DISC ASSEMBLY (for Manual Transmission)

    Click here

  5. REMOVE FLYWHEEL SUB-ASSEMBLY (for Manual Transmission)


    1. A01SEEDC01
      *a Hold

      Using SST, hold the crankshaft.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021
    2. A01SCVG

      Remove the 10 bolts and flywheel sub-assembly.

  6. REMOVE DRIVE PLATE AND RING GEAR SUB-ASSEMBLY (for Automatic Transmission)


    1. A01SEEDC01
      *a Hold

      Using SST, hold the crankshaft.

      SST
      09213-54015   ( 91651-60855 )
      09330-00021
    2. A01SBCC

      Remove the 10 bolts, rear drive plate spacer, drive plate and ring gear sub-assembly and front drive plate spacer.

  7. REMOVE REAR ENGINE OIL SEAL


    1. A01SDTNC01
      *a Cut Position
      *b Protective Tape

      Using a knife, cut off the lip of the rear engine oil seal.

    2. Using a screwdriver, pry out the rear engine oil seal.

      Note


      • Do not damage the surface of the rear engine oil seal press fit hole or the crankshaft.

      • After removing the rear engine oil seal, check the crankshaft for damage. If damaged, smooth the surface with 400-grit sandpaper.

      Tech Tips

      Tape the screwdriver tip before use.