PANORAMIC VIEW MONITOR SYSTEM, Diagnostic DTC:C1626

DTC Code DTC Name
C1626 Steering Angle Sensor Failure

DESCRIPTION


Television Camera Controller
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the steering angle sensor

  • Steering sensor

  • Television camera controller

 Television camera controller
Rear Television Camera Assembly
DTC No. Detection Item DTC Detection Condition Trouble Area DTC Output from
C1626 Steering Angle Sensor Failure A fail flag is transmitted from the steering angle sensor

  • Steering sensor

  • Rear television camera assembly

 Rear television camera assembly

CAUTION / NOTICE / HINT

Note


  • When "!" is displayed on the radio and display receiver assembly after the cable is disconnected from the negative (-) battery terminal, correct the steering angle neutral point.

    Click here

  • Depending on the parts that are replaced or operations that are performed during vehicle inspection or maintenance, calibration of other systems as well as the panoramic view monitor system may be needed.

    Click here

  • The vehicle is equipped with a Supplemental Restraint System (SRS) which includes components such as airbags. Before servicing (including removal or installation of parts), be sure to read the precaution for Supplemental Restraint System.

    Click here

PROCEDURE


  1. CHECK FOR DTC


    1. Clear the DTCs.


      Chassis > Panoramic View Monitor > Clear DTCs
      Chassis > Parking Assist Camera > Clear DTCs

    2. Recheck for DTCs and check that no DTCs are output.


      Chassis > Panoramic View Monitor > Trouble Codes
      Chassis > Parking Assist Camera > Trouble Codes
      Result
      Result Proceed to
      DTC C1626 is output A
      DTC C1626 is not output B

    B

    USE SIMULATION METHOD TO CHECK Click here

    A

  2. REPLACE STEERING SENSOR


    1. Replace the steering sensor with a normally functioning one.

      Click here

      Result
      Proceed to
      NEXT

    NEXT

  3. CHECK FOR DTC


    1. Clear the DTCs.


      Chassis > Panoramic View Monitor > Clear DTCs
      Chassis > Parking Assist Camera > Clear DTCs

    2. Check for DTCs.


      Chassis > Panoramic View Monitor > Trouble Codes
      Chassis > Parking Assist Camera > Trouble Codes
      Result
      Result Proceed to
      No DTCs are output A
      DTC C1626 is output ("Panoramic View Monitor") B
      DTC C1626 is output ("Parking Assist Camera") C

    A

    END (STEERING SENSOR WAS DEFECTIVE)

    B

    REPLACE TELEVISION CAMERA CONTROLLER Click here

    C

    REPLACE REAR TELEVISION CAMERA ASSEMBLY Click here