FRONT SEAT CUSHION HEATER REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization, or registration) that must be performed after parts are removed, installed, or replaced during the front seat cushion heater assembly removal/installation are shown below.

Necessary Procedure After Parts Removed/Installed/Replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative when not performed Link
Disconnect cable from negative battery terminal Memorize steering angle neutral point Lane departure alert system (w/ Steering Control)

Click here

Simple intelligent parking assist system*1
Toyota parking assist-sensor system (w/ Simple Intelligent Parking Assist System)*1
Pre-collision system
Initialize back door lock Power door lock control system

Click here

Drive the vehicle until stop and start control is permitted (approximately 5 to 60 minutes)*2 Stop and start system

Click here

*1: When performing learning using the GTS.

Click here

*2: w/ Stop and start system

CAUTION:


  • B008KCO

    Be sure to read Precaution thoroughly before servicing.

    Click here

  • Wear protective gloves. Sharp areas on the parts may injure your hands.

Tech Tips


  • Use the same procedure for RHD and LHD vehicles.

  • The procedure listed below is for LHD vehicles.

  • Use the same procedure for the driver side and front passenger side.

  • The procedure listed below is for the driver side.

PROCEDURE


  1. REMOVE SEPARATE TYPE FRONT SEATBACK ASSEMBLY

    Click here

  2. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER WITH PAD

    Click here

  3. REMOVE SEPARATE TYPE FRONT SEAT CUSHION COVER

    Click here

  4. REMOVE FRONT SEAT CUSHION HEATER ASSEMBLY

    A001W1P

    1. Remove the 14 tag pins and front seat cushion heater assembly from the separate type front seat cushion cover.