FRONT SEAT INNER BELT ASSEMBLY INSPECTION

PROCEDURE

1. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Driver Side)

   1. 

      *a	Component without harness connected (Front Seat Inner Belt Assembly (for Driver Side))

      w/o Seat Position Airbag Sensor:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      2 - 3	Driver seat belt unfastened	Below 1 Ω
      2 - 3	Driver seat belt fastened	10 kΩ or higher

      If the result is not as specified, replace the front seat inner belt assembly (for Driver Side).

   2. 

      *1	Connector A
      *2	Connector B
      *a	Component without harness connected (Front Seat Inner Belt Assembly (for Driver Side))

      w/ Seat Position Airbag Sensor:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      A-3 (LSP-) - B-1	Always	Below 1 Ω
      A-4 (LSP+) - B-2	Always	Below 1 Ω

      If the result is not as specified, replace the front seat inner belt assembly (for Driver Side).

2. INSPECT FRONT SEAT INNER BELT ASSEMBLY (for Front Passenger Side)

   1. 

      *1	Connector A
      *2	Connector B
      *a	Component without harness connected (Front Seat Inner Belt Assembly (for Front Passenger Side))

      w/o Occupant Detection ECU:

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance

      Tester Connection	Condition	Specified Condition
      A-3 (+) - B-1	Always	Below 1 Ω
      A-2 (E)- B-3	Front passenger seat belt unfastened	Below 1 Ω
      A-2 (E) - B-3	Front passenger seat belt fastened	10 kΩ or higher

      If the result is not as specified, replace the front seat inner belt assembly (for Front Passenger Side).