METER / GAUGE SYSTEM

DTC Code DTC Name
HOW TO PROCEED WITH TROUBLESHOOTING

CAUTION / NOTICE / HINT

Tip:

  • Use the following procedure to troubleshoot the meter / gauge system.

  • *: Use the GTS.

PROCEDURE

  1. VEHICLE BROUGHT TO WORKSHOP

    Result

    Proceed to

    NEXT
    NEXT

  2. CUSTOMER PROBLEM ANALYSIS

    Result

    Proceed to

    NEXT
    NEXT

  3. INSPECT BATTERY VOLTAGE

    1. Measure the battery voltage.

      Standard Voltage

      11 to 14 V

      If the voltage is below 11 V, recharge or replace the battery before proceeding to the next step.

    Result

    Proceed to

    NEXT
    NEXT

  4. CHECK CAN COMMUNICATION SYSTEM*

    1. Check if CAN communication DTCs are output.

      Click hereClick hereClick here

    Result

    Result

    Proceed to

    CAN communication DTCs are not output.

    A

    CAN communication DTCs are output.

    B
    B

    GO TO CAN COMMUNICATION SYSTEM

    Click hereClick here

    A

  5. CHECK FOR DTC*

    1. Check for DTCs.

      Click here

      Body Electrical > Combination Meter > Trouble Codes

    Result

    Result

    Proceed to

    DTCs are not output.

    A

    DTCs are output.

    B
    B

    GO TO DIAGNOSTIC TROUBLE CODE CHART

    Click hereClick hereClick hereClick here

    A

  6. PROBLEM SYMPTOM CONFIRMATION

    Result

    Proceed to

    NEXT
    NEXT

  7. SYMPTOM SIMULATION

    Result

    Proceed to

    NEXT
    NEXT

  8. PROBLEM SYMPTOMS TABLE

    1. Refer to Problem Symptoms Table.

      Click hereClick hereClick here

    Result

    Result

    Proceed to

    Fault is not listed in Problem Symptoms Table.

    A

    Fault is listed in Problem Symptoms Table.

    B
    B

    GO TO PROBLEM SYMPTOMS TABLE

    Click hereClick hereClick here

    A

  9. CIRCUIT INSPECTION

    Result

    Proceed to

    NEXT
    NEXT

  10. REPAIR OR REPLACE

    Result

    Proceed to

    NEXT
    NEXT

  11. CONFIRMATION TEST

    Result

    Proceed to

    NEXT
    NEXT

    END