8GR-FKS SPARK PLUG REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during ignition coil and spark plug removal/installation are shown below.

Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link

  • Ignition coil assembly

  • Spark plug

 Inspection after repair

  • Poor idle, etc.

  • Engine start function, etc.

Click here

PROCEDURE


  1. REMOVE V-BANK COVER SUB-ASSEMBLY

    Click here

  2. REMOVE RADIATOR COVER PLATE

    Click here

  3. REMOVE UPPER RADIATOR SUPPORT SEAL

    Click here

  4. REMOVE LOWER RADIATOR AIR DEFLECTOR

    Click here

  5. REMOVE RADIATOR SUPPORT TO CROSS MEMBER BRACE SUB-ASSEMBLY RH

    Click here

  6. DISCONNECT NO. 2 PCV HOSE

    Click here

  7. REMOVE AIR CLEANER WITH AIR CLEANER HOSE

    Click here

  8. REMOVE IGNITION COIL ASSEMBLY (for RHD)

    Click here

  9. REMOVE IGNITION COIL ASSEMBLY (for LHD)

    Click here

  10. REMOVE SPARK PLUG


    1. Remove the 6 spark plugs from the cylinder head sub-assembly.

      Note

      If a spark plug has been struck or dropped, replace it.