FRONT BRAKE REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The following procedure is for the LH side.

PROCEDURE


  1. REMOVE FRONT WHEEL

  2. DRAIN BRAKE FLUID

    Note

    Immediately wash off any brake fluid that comes into contact with any painted surfaces.

  3. DISCONNECT FRONT FLEXIBLE HOSE


    1. A004QXB

      Remove the union bolt and gasket, and disconnect the front flexible hose from the disc brake cylinder assembly.

  4. REMOVE DISC BRAKE CYLINDER ASSEMBLY


    1. A004O2HE01
      Text in Illustration
      *1 Hold
      *2 Turn

      While holding the front disc brake cylinder slide pin with a wrench, remove the 2 bolts, and then remove the disc brake cylinder assembly from the front disc brake cylinder mounting.

  5. REMOVE FRONT DISC BRAKE PAD


    1. A004TWB

      Remove the 2 disc brake pads from the disc brake cylinder mounting.

  6. REMOVE FRONT DISC BRAKE PAD SUPPORT PLATE


    1. A004SZY

      Remove the 2 disc brake pad support plates LH and 2 disc brake pad support plates RH from the front disc brake cylinder mounting.

      Note

      Each front disc brake pad support plate has a different shape. Be sure to put an identification mark on each front disc brake pad support plate so that it can be reinstalled to its original position.

  7. REMOVE FRONT DISC BRAKE CYLINDER SLIDE PIN


    1. A004QH9

      Remove the 2 front disc brake cylinder slide pins from the disc brake cylinder mounting.

  8. REMOVE FRONT DISC BRAKE CYLINDER SLIDE BUSH


    1. A004NDQE01
      Text in Illustration
      *1 Protective Tape

      Using a screwdriver, remove the front disc brake cylinder slide bush from the front disc brake cylinder slide pin.

      Tech Tips

      Tape the screwdriver tip before use.

      Note

      Do not damage the front disc brake cylinder slide pin.

  9. REMOVE FRONT DISC BRAKE BUSH DUST BOOT


    1. A004OHJ

      Remove the 2 front disc brake bush dust boots from the disc brake cylinder mounting.

  10. REMOVE FRONT DISC BRAKE CYLINDER MOUNTING


    1. A004SAH

      Remove the 2 bolts and front disc brake cylinder mounting from the steering knuckle.

  11. REMOVE FRONT DISC


    1. A004P9ZE01
      Text in Illustration
      *1 Matchmark

      Put matchmarks on the disc and axle hub, and remove the front disc.