INSTRUMENT PANEL SPEAKER INSPECTION

PROCEDURE


  1. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (w/ Woofer)


    1. Check the resistance.


      1. A001V6TC02
        *a

        Component without harness connected

        (Front No. 2 Speaker Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        Tester Connection Condition Specified Condition
        2 (+) - 1 (-) Always 6.8 to 10.2 Ω

        If the result is not as specified, replace the front No. 2 speaker assembly.

  2. INSPECT FRONT NO. 2 SPEAKER ASSEMBLY (w/o Woofer)


    1. Check the resistance.


      1. A001XQFC82
        *A for RH
        *B for LH
        *a

        Component without harness connected

        (Front No. 2 Speaker Assembly)

        Measure the resistance according to the value(s) in the table below.

        Standard Resistance
        for RH
        Tester Connection Condition Specified Condition
        4 (TWR+) - 2 (TWR-) Always 10 kΩ or higher
        1 (-) - 2 (TWR-) Always Below 1 Ω
        3 (+) - 4 (TWR+) Always Below 1 Ω
        for LH
        Tester Connection Condition Specified Condition
        4 (TWL+) - 2 (TWL-) Always 10 kΩ or higher
        1 (-) - 2 (TWL-) Always Below 1 Ω
        3 (+) - 4 (TWL+) Always Below 1 Ω

        If the result is not as specified, replace the front No. 2 speaker assembly.