CYLINDER BLOCK REPLACEMENT

PROCEDURE

  1. REPLACE CYLINDER BLOCK STRAIGHT PIN

    Note:

    It is not necessary to remove the cylinder block straight pin unless it is being replaced.

    1. Remove the cylinder block straight pin.

    2. Using a plastic-faced hammer, tap in a new cylinder block straight pin to the cylinder block sub-assembly.

      Standard Protrusion

      Item

      Specified Condition

      Pin A

      11 mm (0.433 in.)

      Pin B

      7.0 mm (0.726 in.)

      Pin C

      18 mm (0.709 in.)

      Pin D

      7.5 mm (0.725 in.)

      Pin E

      7.5 mm (0.725 in.)
      A298156C01

      *a

      Rear Side

      *b

      Upper Side

      *c

      Lower Side

      *d

      Front Side

      *e

      Crankshaft Bearing Cap Exhaust Side

      -

      -
    3. A206566

      Using a plastic-faced hammer, tap in new cylinder block ring pins to the crankshaft bearing cap.

      Standard protrusion

      6.5 mm (0.256 in.)