PRE-COLLISION SYSTEM ECU Power Source Circuit

DESCRIPTION

This circuit supplies power to the driving support ECU assembly when the engine switch is on (IG).

WIRING DIAGRAM

B006F1DN06

CAUTION / NOTICE / HINT

Note


  • w/o Stop and Start System:

    Inspect the fuses for circuits related to this system before performing the following inspection procedure.

  • w/ Stop and Start System:

    As the driving support ECU assembly is supplied power from the engine stop and start ECU, make sure that the stop and start system is not malfunctioning before performing the following inspection procedure.

PROCEDURE


  1. CHECK DRIVING SUPPORT ECU ASSEMBLY (B VOLTAGE)


    1. Disconnect the G68 driving support ECU assembly connector.

    2. Measure the voltage according to the value(s) in the table below.

      Standard Voltage
      Tester Connection Condition Specified Condition
      G68-7 (B) - Body ground Engine switch on (IG)

      11 to 14 V*1

      10.5 to 16 V*2

      • *1: w/o Stop and Start System

      • *2: w/ Stop and Start System

    3. Reconnect the G68 driving support ECU assembly connector.

      Result
      Proceed to
      OK
      NG (w/o Stop and Start System)
      NG (w/ Stop and Start System)

    NG (w/o Stop and Start System)

    REPAIR OR REPLACE HARNESS OR CONNECTOR

    NG (w/ Stop and Start System)

    GO TO STOP AND START SYSTEM (BACKUP BOOST CONVERTER CIRCUIT) for 8GR-FKS: Click here
    GO TO STOP AND START SYSTEM (BACKUP BOOST CONVERTER CIRCUIT) for V35A-FTS: Click here

    OK

  2. CHECK HARNESS AND CONNECTOR (DRIVING SUPPORT ECU ASSEMBLY - BODY GROUND)


    1. Disconnect the G68 driving support ECU assembly connector.

    2. Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      G68-28 (GND) - Body ground Always Below 1 Ω

    3. Connect the G68 driving support ECU assembly connector.

      Result
      Proceed to
      OK
      NG

    OK

    PROCEED TO NEXT SUSPECTED AREA SHOWN IN PROBLEM SYMPTOMS TABLE Click here

    NG

    REPAIR OR REPLACE HARNESS OR CONNECTOR