PROPELLER SHAFT ASSEMBLY DISASSEMBLY

CAUTION / NOTICE / HINT

Note


  • When using a vise, place aluminum plates between the part and vise.

  • When using a vise, do not overtighten it.

PROCEDURE


  1. REMOVE PROPELLER SHAFT ASSEMBLY


    1. A01R9DZC02
      *a Matchmark

      Place matchmarks on the propeller shaft assembly and universal joint flange.

      Note

      Do not use a punch for the marks.

    2. Remove the 4 nuts, 4 bolts, 4 washers and propeller shaft assembly.

  2. REMOVE INTERMEDIATE SHAFT ASSEMBLY


    1. A01R904C02
      *a Matchmark

      Place matchmarks on the rear propeller shaft assembly and universal joint flange.

      Note

      Do not use a punch for the marks.

    2. Using a 6 mm hexagon socket wrench, remove the 6 cross groove joint set bolts, 2 universal joint washers and intermediate shaft assembly.

  3. REMOVE CENTER NO. 2 SUPPORT BEARING ASSEMBLY (for Rear Side)


    1. A01RC3MC01
      *a Matchmark

      Place matchmarks on the intermediate shaft assembly and universal joint flange.

      Note

      Do not use a punch for the marks.

    2. A01RE4HN02

      Using SST and a hammer, release the staked part of the nut.

      SST
      09930-00010

      Note

      Release the staked part of the nut completely, otherwise the threads of the intermediate shaft assembly may be damaged.

    3. A01RAJJC01
      *a Turn
      *b Hold

      Using SST to hold the universal joint flange, remove the nut and washer.

      SST
      09330-00021
    4. A01RCTWC01
      *a Turn
      *b Hold

      Using SST, remove the universal joint flange from the intermediate shaft assembly.

      SST
      09950-40011   ( 09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04061, 09957-04010, 09958-04011 )

      Note


      • Be careful not to damage the universal joint flange.

      • Do not overtighten the vise.

      • Apply grease to the threads and tip of the center bolt of SST before use.

    5. Remove the center No. 2 support bearing assembly and washer from the intermediate shaft assembly.

  4. REMOVE CENTER NO. 2 SUPPORT BEARING ASSEMBLY (for Front Side)


    1. A01RFB1C01
      *a Matchmark

      Place matchmarks on the intermediate shaft assembly and universal joint flange.

      Note

      Do not use a punch for the marks.

    2. A01RDH7N02

      Using SST and a hammer, release the staked part of the nut.

      SST
      09930-00010

      Note

      Release the staked part of the nut completely, otherwise the threads of the intermediate shaft assembly may be damaged.

    3. A01RB6IC01
      *a Turn
      *b Hold

      Using SST to hold the universal joint flange, remove the nut and washer.

      SST
      09330-00021
    4. A01RB5DC01
      *a Turn
      *b Hold

      Using SST, remove the universal joint flange from the intermediate shaft assembly.

      SST
      09950-40011   ( 09951-04020, 09952-04010, 09953-04030, 09954-04010, 09955-04061, 09957-04010, 09958-04011 )

      Note


      • Be careful not to damage the universal joint flange.

      • Do not overtighten the vise.

      • Apply grease to the threads and tip of the center bolt of SST before use.

    5. Remove the center No. 2 support bearing assembly and washer from the intermediate shaft assembly.