ECM REMOVAL

PROCEDURE

1. PRECAUTION

   Note:

   After turning the ignition switch off, waiting time may be required before disconnecting the cable from the negative (-) battery terminal. Therefore, make sure to read the disconnecting the cable from the negative (-) battery terminal notice before proceeding with work.

   Click hereClick hereClick hereClick here

2. DISCONNECT CABLE FROM NEGATIVE BATTERY TERMINAL

   Note:

   When disconnecting the cable, some systems need to be initialized after the cable is reconnected.

   Click hereClick hereClick hereClick hereClick hereClick here

3. REMOVE NO. 1 ENGINE COVER

   Click hereClick hereClick hereClick here

4. REMOVE AIR CLEANER CAP SUB-ASSEMBLY

   Click here

5. REMOVE AIR CLEANER CASE SUB-ASSEMBLY

   Click hereClick hereClick hereClick here

6. SEPARATE NO. 1 AIR CLEANER INLET

   1. 

      Remove the bolt.

7. REMOVE ECM

   1. 

      Raise the 2 levers while pushing the locks on the levers, and disconnect the 2 ECM connectors.

   2. Disengage the wire harness clamp.

   3. 

      Remove the 2 bolts, clamp and the ECM with ECM brackets.

      Note:

      • If a component has been dropped or subjected to a strong impact, replace it.

      • After disconnecting the connectors, make sure that dirt, water or other foreign matter does not contact the connecting parts of the connectors.

8. REMOVE NO. 1 ECM BRACKET

   1. 

      Remove the 2 screws and No. 1 ECM bracket from the ECM.

9. REMOVE NO. 2 ECM BRACKET

   1. 

      Remove the 2 screws and No. 2 ECM bracket from the ECM.