WIPER SWITCH REMOVAL

CAUTION / NOTICE / HINT

Tech Tips


  • Use the same procedure for the LHD and RHD vehicle.

  • The procedure listed below is for the LHD vehicle.

PROCEDURE


  1. REMOVE INSTRUMENT SIDE PANEL LH

    Click here

  2. REMOVE INSTRUMENT PANEL ORNAMENT (w/ Large Ornament Panel)

    Click here

  3. REMOVE CENTER INSTRUMENT CLUSTER FINISH PANEL SUB-ASSEMBLY (w/o Large Ornament Panel)

    Click here

  4. REMOVE METER HOOD SUB-ASSEMBLY

    Click here

  5. REMOVE UPPER INSTRUMENT PANEL METER ORNAMENT

    Click here

  6. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/o Knee Airbag)

    Click here

  7. REMOVE NO. 1 INSTRUMENT PANEL UNDER COVER SUB-ASSEMBLY (w/ Knee Airbag)

    Click here

  8. REMOVE STEERING COLUMN COVER SUPPORT (w/ Entry and Start System)

    A004ILK

    1. Disengage the 4 claws and remove the steering column cover support.

  9. REMOVE LOWER STEERING COLUMN COVER


    1. A004IN6

      While turning the steering wheel assembly to the right and left, remove the 2 screws.

    2. A004KUY

      w/ Knee Airbag


      1. Disengage the 4 claws and remove the lower steering column cover.

    3. A004JLL

      w/o Knee Airbag


      1. Disengage the 6 claws and remove the lower steering column cover.

  10. REMOVE UPPER STEERING COLUMN COVER


    1. A004IEE

      Disengage the 2 claws and remove the upper steering column cover.

  11. REMOVE WINDSHIELD WIPER SWITCH ASSEMBLY

    A004IU7E01
    Text in Illustration
    *1 Protective Tape

    1. Disconnect the 2 connectors.

    2. Using a screwdriver, disengage the claw and remove the windshield wiper switch assembly as shown in the illustration.

      Note

      Do not press the claw too hard, as it may get damaged.

      Tech Tips

      Tape the screwdriver tip before use.