CYLINDER BLOCK REPLACEMENT

PROCEDURE

  1. REPLACE RING PIN

    Note:

    It is not necessary to remove the ring pins unless they are being replaced.

    1. Remove the 2 ring pins.

    2. A198047C04

      *a

      Upper Side

      Using a plastic hammer, tap in the 2 ring pins.

      Protrusion Height

      6.0 to 7.0 mm (0.236 to 0.276 in.)

  2. REPLACE STRAIGHT PIN

    Note:

    It is not necessary to remove the straight pins unless they are being replaced.

    1. Remove the 4 straight pins.

    2. Using a plastic hammer, tap in the 4 straight pins.

      A286171C02

      *a

      Front Side

      *b

      Rear Side

      Protrusion Height

      Item

      Protrusion Height

      Pin A

      5.5 to 6.5 mm (0.217 to 0.256 in.)

      Pin B

      11.5 to 12.5 mm (0.453 to 0.492 in.)