GLOW PLUG ON-VEHICLE INSPECTION

PROCEDURE


  1. CHECK GLOW PLUG


    1. Remove the glow plug connector.

      Click here

    2. A01L8YB

      Measure the resistance according to the value(s) in the table below.

      Standard Resistance
      Tester Connection Condition Specified Condition
      Glow plug terminal - Body ground 20°C (68°F) Approximately 1.0 Ω

      If the result is not as specified, replace the glow plug assembly.

      Note


      • Be careful not to damage the glow plug assemblies, as this may cause an open circuit or shorten the life of the glow plug assemblies.

      • Do not allow oil or gasoline to contact the glow plug assembly when cleaning it.

      • Clean off any oil on the terminal with a dry cloth.

      • Do not apply more than 11 V to the glow plug assembly, as this may cause an open circuit.

    3. Install the glow plug connector.

      Click here