AIR FUEL RATIO SENSOR(for Sensor 1) REMOVAL

PROCEDURE

1. REMOVE WINDSHIELD WIPER MOTOR AND LINK ASSEMBLY

   Click here

2. REMOVE WATER GUARD PLATE LH

   • for LHD:

     Click hereClick hereClick hereClick here

   • for RHD:

     Click here

3. REMOVE NO. 2 HEATER AIR DUCT SPLASH SHIELD SEAL

   • for LHD:

     Click hereClick hereClick hereClick here

   • for RHD:

     Click here

4. REMOVE OUTER COWL TOP PANEL

   • for LHD:

     Click hereClick hereClick hereClick here

   • for RHD:

     Click here

5. REMOVE AIR FUEL RATIO SENSOR

   1. 

      Disengage the wire harness clamp.

   2. Disconnect the air fuel ratio sensor connector.

   3. 

      Using SST, remove the air fuel ratio sensor from the exhaust manifold converter sub-assembly.

      09224-00011

      Note:

      If the air fuel ratio sensor has been struck or dropped, replace it.