THROTTLE BODY INSTALLATION

PROCEDURE

  1. INSTALL THROTTLE BODY GASKET

    1. A425998C01

      *a

      Protrusion

      Install a new throttle body gasket to the intake manifold with the protrusion of the throttle body gasket oriented as shown in the illustration.

  2. INSTALL THROTTLE BODY WITH MOTOR ASSEMBLY

    1. Using an 8 mm socket wrench, install the throttle body with motor assembly to the intake manifold with the 3 bolts.

      10 N*m

      102 kgf*cm

      7 ft.*lbf

      Note:

      If the throttle body with motor assembly has been struck or dropped, replace it.

    2. A425996C01

      *1

      No. 1 Water By-pass Hose Assembly

      *2

      No. 2 Water By-pass Hose Assembly

      *a

      Top

      *b

      Front of Vehicle

      *c

      Rear of Vehicle

      *d

      Paint Mark

      *e

      90° (Claw of Clip Location)

      Connect the No. 1 water by-pass hose assembly and No. 2 water by-pass hose assembly to the throttle body with motor assembly and slide the 2 clips to secure them.

      Note:

      Make sure to position each clip as shown in the illustration.

    3. Connect the throttle body with motor assembly connector.

  3. INSTALL AIR CLEANER CAP SUPPORT

    1. A425993C01

      *a

      Right Side of Vehicle

      *b

      Front of Vehicle

      *c

      120° (Claw of Clip Location)

      Install the air cleaner cap support to the throttle body with motor assembly and slide the clip to secure it.

      Note:

      Make sure to position the clip as shown in the illustration.

  4. INSTALL AIR CLEANER ASSEMBLY WITH DUCT

    1. Set the air cleaner assembly with duct on the air cleaner cap support, No. 2 ventilation hose and cylinder head cover sub-assembly.

    2. Insert the air cleaner assembly with duct into the air cleaner cap support.

      Note:

      Insert the air cleaner cap sub-assembly until its stopper contacts the air cleaner cap support.

    3. Engage the air cleaner assembly with duct to the No. 2 ventilation hose and cylinder head cover sub-assembly.

    4. A425991C01

      *1

      Air Cleaner Assembly with Duct

      *2

      No. 2 Ventilation Hose

      *3

      Cylinder Head Cover Sub-assembly

      *a

      Front of Vehicle

      *b

      Left Side of Vehicle

      *c

      Top

      *d

      1.0 to 7.0 mm (0.0394 to 0.276 in.)

      *e

      30°

      *f

      Clip

      Slide the clip to secure the No. 2 ventilation hose.

      Note:

      Make sure to position the clip as shown in the illustration.

    5. Install the air cleaner assembly with duct with the 2 bolts.

      7.8 N*m

      80 kgf*cm

      69 in.*lbf

  5. ADD ENGINE COOLANT

  6. INSPECT FOR COOLANT LEAK

  7. PERFORM INITIALIZATION

    Note:
    • Be sure to perform this procedure after removing and reinstalling the throttle body with motor assembly or any throttle body with motor assembly components.

    • Perform the following procedure after replacing the throttle body with motor assembly or any throttle body with motor assembly components. The following procedure should also be performed if the throttle body with motor assembly is cleaned.

    1. Perform "electronic throttle learning".

      Click here