REAR COMBINATION LIGHT ASSEMBLY REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are installed, removed or replaced during the rear combination light assembly removal/installation are shown below.

Necessary procedure after parts removed/installed/replaced
Replacement Part or Procedure Necessary Procedures Effects/Inoperative Functions when not Performed Link

    w/ Parking Support Brake System:

  • Rear bumper assembly (Including removal and installation)

  • Ultrasonic sensor detection angle

  • Ultrasonic sensor detection angle registration

 Parking support brake system

Click here

Tech Tips


  • Use the same procedure for the RH and LH sides.

  • The procedure described below is for the LH side.

PROCEDURE


  1. REMOVE LUGGAGE COMPARTMENT FLOOR MAT

    Click here

  2. REMOVE LUGGAGE COMPARTMENT TRIM COVER LH

    Click here

  3. REMOVE LUGGAGE COMPARTMENT TRIM COVER RH

    Click here

  4. REMOVE LUGGAGE COMPARTMENT TRIM BOX (w/ Luggage Compartment Trim Box)

    Click here

  5. REMOVE ROPE HOOK ASSEMBLY

    Click here

  6. REMOVE REAR FLOOR FINISH PLATE

    Click here

  7. REMOVE NO. 2 ROPE HOOK


    1. B006AEVC01
      B006EC9 Push
      B006DHE Remove in this Direction

      Push the 2 knobs and remove the No. 2 rope hook.

  8. REMOVE REAR COMBINATION LIGHT COVER LH

    Click here

  9. REMOVE REAR COMBINATION LIGHT COVER RH

    Tech Tips

    Use the same procedure described for the LH side.

  10. REMOVE REAR BUMPER ASSEMBLY

    Click here

  11. REMOVE REAR COMBINATION LIGHT ASSEMBLY LH


    1. B006E4WC01
      B006GBM Protective Tape

      Apply protective tape around the rear combination light assembly LH.

    2. B006DD4C01
      B006AHR Clip
      B006EC9 Clip Holder

      Remove the clip and clip holder.

    3. B006BXC

      Fold back the rear side of the luggage compartment trim inner cover LH and disconnect the connector as shown in the illustration.

    4. B006EZ1

      Remove the 4 screws.

    5. B006GKWC01
      *a Guide
      *b Pin
      B006DHE Remove in this Direction

      Slide the rear combination light assembly LH toward the rear of the vehicle to detach the guide, pin and clip.

    6. B006F7J

      Remove the grommet and pull out the wire harness.