THERMOSTAT REMOVAL

CAUTION / NOTICE / HINT

The necessary procedures (adjustment, calibration, initialization or registration) that must be performed after parts are removed and installed, or replaced during thermostat removal/installation are shown below.

Necessary Procedures After Parts Removed/Installed/Replaced
Replaced Part or Performed Procedure Necessary Procedure Effect/Inoperative Function when Necessary Procedure not Performed Link
Battery terminal is disconnected/reconnected Perform steering sensor zero point calibration Lane departure alert system (w/ Steering Control)

Click here

Pre-collision system
Memorize steering angle neutral point Parking assist monitor system

Click here

Panoramic view monitor system

Click here

PROCEDURE


  1. DRAIN ENGINE COOLANT

    Click here

  2. REMOVE GENERATOR ASSEMBLY

    Click here

  3. DISCONNECT NO. 2 RADIATOR HOSE

    Click here

  4. REMOVE WATER INLET


    1. B0085YT

      Remove the 2 nuts and water inlet.

  5. REMOVE THERMOSTAT


    1. Remove the thermostat from the water inlet housing.

    2. Remove the gasket from the thermostat.