VEHICLE STABILITY CONTROL SYSTEM, Diagnostic DTC:C1433

DTC Code	DTC Name
C1433	Steering Angle Sensor Internal Circuit

DESCRIPTION

Signals from the steering angle sensor (spiral with sensor cable sub-assembly) are sent to the skid control ECU (brake actuator assembly) through CAN communication.


DTC No.	Detection Item	DTC Detection Condition	Trouble Area
C1433	Steering Angle Sensor Internal Circuit	With the IG1 terminal voltage 9.5 to 17.4 V, the skid control ECU receives an error signal from the steering angle sensor.	Steering angle sensor (Spiral with sensor cable sub-assembly)

WIRING DIAGRAM

Refer to DTC C1432.

Click here

CAUTION / NOTICE / HINT

Tip:

When U0073, U0124 and/or U0126 is output together with C1433, inspect and repair the trouble areas indicated by U0073, U0124 and/or U0126 first.
Click here
When any of the speed sensors or the yaw rate and acceleration sensor (airbag sensor assembly) has trouble, DTCs for the steering angle sensor (spiral with sensor cable sub-assembly) may be output even when the steering angle sensor (spiral with sensor cable sub-assembly) is normal. When DTCs for the speed sensors or yaw rate and acceleration sensor (airbag sensor assembly) are output together with DTCs for the steering angle sensor (spiral with sensor cable sub-assembly), inspect and repair the speed sensor and yaw rate and acceleration sensor (airbag sensor assembly) first, and then inspect and repair the steering angle sensor (spiral with sensor cable sub-assembly).

PROCEDURE

REPLACE SPIRAL WITH SENSOR CABLE SUB-ASSEMBLY

Replace the spiral with sensor cable sub-assembly.
Click here
Note:
- Do not remove the steering angle sensor from the spiral with sensor cable sub-assembly.
- When replacing the spiral with sensor cable sub-assembly, confirm that the replacement part is of the correct specification.
Tip:
If troubleshooting has been carried out according to the Problem Symptoms Table, refer back to the table and proceed to the next step.

Click here

Result


Proceed to
NEXT